SuperMicro X9SCM-F

BugginOuT

Limp Gawd
Joined
May 14, 2008
Messages
463
Not sure if this belongs here or in the Intel forum.

I recently purchased the board listed on the Title, but got an Intel Xeon E3-1230 v2 CPU along with it. I believe the board hasn't been updated with the latest BIOS to support v2 series. I would get 3 or 4 beeps when powering on the box with no display.

Would it be possible for me to install my 3570K on this board, so that I can update the BIOS?
 
beeping is signalling faulty or no RAM or GPU, if CPU wouldn't be recognized by bios, there wouldn't be any beeping, so the CPU works, but something else not, check the RAM and graphics
 
GPU is integrated, didn't think about the RAM, will try that tonight when I get home. Thx.
 
Saw this on SuperMicro's website:

BIOS rev. 2.0 or above is needed to support new E3-1200 v2 CPUs, which supports PCI-E 3.0 & DDR3 1600.

Perhaps that's why none of the RAM configs are working. Either I RMA this board back and hope to get a revision 2.0 replacement or look for an E3-1200 CPU to update the BIOS.
 
Last edited:
Both of the x9scm-f boards that I received within the last two weeks were both at 1.11a, needing the 2.0a update. My source was Newegg on both.

One word of warning if you do the bios update. Make sure you run the second step of the bios upgrade after the first reboot, and that the update script doesn't give any errors or warning. The earlier bios updates for this board did not require this second step, as their script make the required updates all in one go.
 
Update: I just booted one new board that I received yesterday, and it already had BIOS 2.0. So unless they still have some of the older ones on the shelf, Newegg is now delivering 2.0 BIOS enabled boards. I am now making the 2.0a update, but 2.0 is good enough to natively boot Ivybridge.
 
Back
Top