SuperLANBoy cooling questions.

[JaYp146]

Hey guys,

I'd like to keep blue 120mm LED fans (both Antec) in both the intake and exhaust ports of my Antec SuperLANBoy. I'm running a 3200+ Venice (soon-to-be x2 3800+ Manchester) under a TR2 Silent Boost, 7800GT under an Arctic Cooling Accelero X1, 2 hard drives, with a Sunbeamtech NUUO 550w PSU.

My temps look something like this:

Motherboard: 35 C
CPU: 41 C
GPU: 46C
Hard drives: 40C and 34C
PSU: 51C

Any suggestions as to how I might go about decreasing these temps? Are there high CFM / low dB 120mm blue LED fans out there that might be good replacements for the Antecs? While I appreciate the low-noise output of my PC...are these temperatures okay? Any other suggestions...?

Thanks in advance, you guys pwn.

 

[nooh]

Is your cpu overclocked?, if not then is it at1.37v , I remember when i had my venice the bios had it quite overvolted which did give me alot of heating problems, also what hsf you using?
I was using a freezer 64 which was good and my freind had a typhoon whos performance is unbeatable but it is huge.

 

[JaYp146]

Is your cpu overclocked?, if not then is it at1.37v , I remember when i had my venice the bios had it quite overvolted which did give me alot of heating problems, also what hsf you using?
I was using a freezer 64 which was good and my freind had a typhoon whos performance is unbeatable but it is huge.

TR2 Silent Boost K8. http://www.hampton-technologies.com/SilentBoostK8.htm

Rather underrated, IMHO.

It's not overclocked. I've kept my ASRock Dual939-SATA2 @ the original BIOS (1.2) for a while now...I may experiment with the OCWorkbench BIOSes in the near future.

 

[nooh]

TR2 Silent Boost K8. http://www.hampton-technologies.com/SilentBoostK8.htm

Rather underrated, IMHO.

It's not overclocked. I've kept my ASRock Dual939-SATA2 @ the original BIOS (1.2) for a while now...I may experiment with the OCWorkbench BIOSes in the near future.

Yopur right on that i had a akasa one similar to that and it performed better than freezer 64.

Check your voltage though cos temps are not right , abit high and usually it is high on the bios
check with ioverclocking results and speed and see what there temps are and put it to that(yes i realise its not overclocked0

You can find out that way how much you need for a certain speed on average. That is the way i overclock , if i sstay in the average voltages , then i have no fear and i am in within margin and on the right line. Run Prime and decrease voltage until you get no errors