::Stupid:: Memory Upgrade Question

fester8542

n00b
Joined
Jan 12, 2005
Messages
3
:eek:
Hey guys. Great forum you got here. Just stumbled across it. Hopefully you can help me out.

****************

Ok I fully dont understand this.
Please forgive me if this is a really dumb question.

Here is my board.
Its an Abit - IS7E
http://www.abit-usa.com/products/mb...ries=1&model=80

Currently I have 512MB (2X256MB) of PC3200 DDR-400 Installed in it. I am looking at upgrading it to 1 GB. Obviously there are two available slots. Can I just throw a single 512 stick in any one of them (leaving one open) or do I need to match two more 256 or 512 sticks?

Sorry...I should probably know the answer to this

Thanks in advance.
 
I had the K7N2-Delta ... and I was able to run 2x256 & 1x512 in dual channel mode ... so it should work ...
 
Your manual will tell you which combinations are feasible and which ones are required for dual channel operation.

I'll look at the manual when I get a chance and update.

EDIT: Ok, checked the manual. You'll need to use either 2 or 4 DIMMs if you want to run dual channel (and you definately do unless you want your system performance to tank). If you're using 4 DIMMs, they all have to be the same size. So, in your case, they would all need to be 256MB (4x256MB)
 
865PE chipset means you need pairs of RAM for dual-channel. You could throw in a single 512, but it actually stands a chance of slowing you down over all, because you would be cutting the effective bandwidth in half (6.4GB/s down to 3.2GB/s).

Primea:
K7N2-Delta is based on the nForce2 chipset, which is unique in the entire history of computers. It was capable of running odd sets of RAM in dual-channel mode in very specific circumstances. To be more precise (IIRC), the total amount of RAM in Channel B could not exceed the single stick in Channel A, though it could match it.
IOW:
A: 1x512
B: 2x256
Dual

A: 1x512
B: 2x512
Single

A: 1x512
B: 1x256
I think it's dual, but I'm not sure.
 
I'm running 3 512MB's crappy generic high latency DDR400 right now in Dual Channel without a problem. In fact I don't knwo how to turn dual channel off :) Its on a MSI K7N2 (6570e)

Disregard this then, I didn't realize this was a question on an Intel set. Yes on Intel the sticks have to match.
 
Back
Top