Steps to take before installing a new MB?

NeWcS

n00b
Joined
Nov 30, 2005
Messages
25
With-in the next month Ill be upgrading my MB, CPU and ram. wanted to know what steps to take before pulling the old and putting in the new so Vista will not die on my first reboot. Im just talking drivers and such NOT vista activation issues.

Thank you

-Jay
 
Keep in mind a lot of the newer boards and chipsets are natively supported by Vista.

As a for instance many people had tons of problems installing Vista on the 680i chipset because the first thing they did was grab the driver CD that came with their board and installed those drivers, then blamed the MOBO manufacture and vista for all the problems. The fact is that on a clean drive if you do a Vista install on that same board it’s ready to run.

Assuming you are buying a newer design board Vista usually will catch the NIC, the Chipset and the video drivers, not to mention most SATA controllers and IDE controllers.

My on going experience is the after market people, Creative for one has yet to make a really good driver for some of their sound cards for Vista.

Things to beware of are a lot of companies like HP, Adaptec and number of others have simply refused to write drivers for a lot of their older products.

Figure out what you want first, and then make sure the drivers already exist.

Another thing to keep in mind is RAM. Vista will run on one gig, but it really likes two gigs and right now RAM is dirt cheap. If you are going for a big time over clock try to avoid populating all four RAM slots, it won’t totally kill your OC but it will limit it a bit.

Make sure you get a big enough PSU the first time, stick with a good brand name, check the PSU forums here for some suggestions. I run a PSU with three 12 volt rails at 19 AMPS per rail, if I were going SLI or CrossFire I would want a bigger PSU.

Just some stuff to think about before you make those final decisions and click the “Buy” button.

Luck;) :D
 
So will I want to uninstall all my old drivers before putting the new board in? Or will vista just disregard them and find the new ones?


-Jay
 
So will I want to uninstall all my old drivers before putting the new board in? Or will vista just disregard them and find the new ones?


-Jay


Vista will wipe them out and supply as many as possible from it's pretty good database.

One really big thing I ask, don't install it and an hour later say it sucks, take the time to use it, break it (which is much harder then you might think). For certain I am no FB of Ms products but Vista is the very best out of box experience I have ever seen with any OS so take a few weeks to get to know it. Install is quite fast so if you don't like what you did reinstall it.

Prior to regestering the OS you can prettu much do as you please with itl

Enjoy;)
 
Back
Top