Sparkle Non-reference Volt Mod?

[Welshsteel]

Ok i've been following the guide at this link

http://www.xtremesystems.org/forums/showthread.php?p=2821966

but i'm not a member of this forum so cant ask about the one missing bit of advice.

I know where to solder the resitor to the phase controller but i don't know where the ground points are. I was wondering if anyone could point out a few ground points near the phase controller.

I've included a picture of the solder point and one of the card if anyone could help would be much apprieciated. Cheers

 

[vanilla_guerilla]

register.

 

[Fharakin]

I so wanted to use paint and draw little arrows and circles, but the truth of the matter is I don't know, and am very lazy today.

 

[Welshsteel]

I have registered. Its just not activated yet and im itching to do the mod tonight.

I have a hr 03 on the card with an xilence fan and the temps never rise above 45.

I'm sure with a higher voltage i could overclock it like a beast. Can anyone help?