Spare parts build

Joined
Jan 8, 2006
Messages
37
In my attempts to put together a rig with spare parts lying around I have run into a problem that is beyond me. The build is as follows:
CPU: e4300
VGA: x300 I think(putting in my 7900gs when I upgrade my current card)
Ram: OCZ DDR2-667 2GB
Mobo: ga-945p-s3
PSU: Cooler Master Extreme 430w(getting new psu when I put in 7900gs)
HDD: WD 80gb IDE
Some old cd drive

When I first hooked up the pc it asked me to insert boot disk, so I complied. It could not find my hdd. I tooled around a bit more and now it will post and continuously restart after posting. If i unplug the cd drive it very very slowly posts and asks me to insert boot disk, which I can't of course because the drive is unplugged. Also when it posts it sets my fsb default at 50 so my e4300 is running at 450mhz. Is my harddrive shot? Is the psu not sufficient? Any help would be greatly appreciated.
 
Found the problem, it's something with the ide hdd. I swapped in my hdd from this rig and it fired up perfectly, so I'll just have to go out and buy a cheap sata hdd. Thanks for your help though.
 
Did you set the jumpers properly on the IDE drive? If you've got it set as a slave instead of a master or vice-versa you'd get the symptoms you descibe.
 
Back
Top