Some help with my P5B Vanilla / e6400 OC?

mmilo

n00b
Joined
Jan 14, 2007
Messages
6
Hi guys,

Does this sound right? I know everyone's board/CPU will differ, but this still doesn't seem right.

My specs:

C2D E6400
Arctic Freezer 7 Pro
OCZ Platinum 2x1GB PC6400
Asus P5B Vanilla

I've run ORTHOS for about 3hours or so with the following settings:

400 FSB (1:1 DRAM ratio)
1.4625 VCore (in BIOS)
2.1 VDIMM
1.4 VCORE
Timings 4-4-4-12-6-42-12-12-12-12

Idle is around 40°c or so.

Judging from what I've seen around, this voltage seems rather high for these settings. And it's not even completely stable ...

Thanks!
 
could be your subtimings are not being read correctly...12-12-12-12 is kind of weird. My subtimings are 5-42-3-14-11-3-8-5-5. Yes your voltages are way high. I need 1.35vcore and 1.95vmem for my e6400 and Corsair 6400C5 at 400FSB.

Note 400 is on the lower strap, also if you go to 401 you will be on a higher strap, with more chipset latency but you will be more stable.

Google Memset, download it, and use its subtimings for your memory and see if that helps.
 
A quick update. Things aren't going too well ..

ORTHOS seemed to hold for around an hour with 401 FSB and VDIMM 2.0, but won't seem to hold for anything less than 1.4vcore.

I'm trying to work my way up, but things aren't going to well.

I haven't played around with my memory subtimings yet, I did reset them back to 5-5-5-15-6-42-15-15-15-15 in the BIOS though.

Also, Speedfan is reporting my temperatures at least 6°c hotter than CoreTemp, which is more reliable?
 
Two more suggestions. Try setting vDimm to 2.1v, and just set the first four memory timings manually; leave the rest on Auto. Does that help?

As for temps, go with Core Temp. It is more accurate, hands down. The reason (short version) is that Core Temp gets its reading from inside the CPU itself, while SpeedFan reads a sensor near the CPU socket.
 
BUMP!

I'm not sure how to use MemSet to set the first 4 settings while the rest are on auto - it seems to be all or nothing.

I can't even seem to get it stable for more than 10seconds on 1.525 VCore (BIOS) and 425 FSB.


Not that an OC of 100% is bad, but I just thought I'd be able to go higher. Perhaps it's the CPU itself that isn't too good?

Note: I'm currently just stressing the CPU and not a blend with ORTHOS, soooo...

Edit: I noticed during the POST screen (which flashes by very quickly) that it says my ram (in dual channel mode) is at PC4300? Is it supposed to read lik that?
 
Back
Top