soldering

dont know about videos, but hold the iron onto what you want to solder until it heats up, then -slowly- touch the solder into it to make a small bead. Dont practice on anything important... get a wire and a piece of metal or something and mess around until you get your technique down. Soldering onto a chip is trickier than soldering metal/metal.
 
Alright, I found an okay guide with a few pictures, but haven't tried yet. The reason for all this is that I am rewiring my car audio, and I'd rather solder and heatshrink wires together than crimp them or do the old-fashioned twist-and-tape-together.

I have a real cheap off-brand soldering iron and some 60/40 solder...well, I'll give it a go. so for this I assume I'd sort of intertwine the two exposed wires, heat them, them add some solder? Would you suggest heatshrinking none, one, or both exposed connections before putting heatshrink over the whole thing?
 
There's no benefit to soldering for a car stereo. In fact, wire nuts will make making changes later easier.
 
You'll be amazed how long a twist-and-tape method will last. The problem with the solder method is that the in-dash wires sometimes aren't long enough for a comfortable/safe soldering job. I used quick-disconnect (in case I made a mistake) crimp connectors from radioshack.
 
mich43L said:
You'll be amazed how long a twist-and-tape method will last. The problem with the solder method is that the in-dash wires sometimes aren't long enough for a comfortable/safe soldering job. I used quick-disconnect (in case I made a mistake) crimp connectors from radioshack.

Same here. My crimp connectors and "Twist and tape " have lasted almost 10 years for the system in the Pontiac Sunbird I'm about to sell this month.
 
Respectfully disagree. I think a soldered connection is a better solution in a high vibration environment like a car. Wire-to-wire connections open to the air (even within a wirecap) are also more susceptible to oxidation and corrosion issues. Soldering is the way to go for car audio imo.

As for quick changes later, firstly I don't think it would add much additional effort, and more importantly, do you want it done right, or do you want it done quick?

A cordless iron works great for under dash work, even those cheap butane ones can be had for about $10.
 
agent420 said:
and more importantly, do you want it done right, or do you want it done quick?
I want it done right and quick, meaning crimp connections or wire nuts.
 
there are some websites that sell electronics kits.. to buidl shit like.. an alarm or a siren.. they give you all the parts you need...

you should use that to learn how to solder...
 
its not too hard. if you feel like sending the harness to me, i can solder it for you... i have lots of free time, and nothing to do... :rolleyes:
 
Back
Top