Socket 1366 Board Latch Bar Bending

rennocneb

Limp Gawd
Joined
May 24, 2007
Messages
136
Hey i have a question ive built probably 500 systems in my time. I work at a local computer shop. When assembling my latest gaming system i noticed that when latched there seems to be way more pressure on the little level that latches the socket closed than on a 775 board. To the point the little bar actaully bows in the middle. Its working fine but im a bit worried about long term reliability of it. Anyone else seen this is the core i7 just bigger meaning the bar goes farther? is it that the core i7 requires more clamping pressure?
 
i've only taken apart one corei7 system. The clamp seemed a little tighter but nothing that i thought i needed to be concerned about. I didn't pay attention to any bowing.
 
I noticed it too - I think it is because of the torx screws around the base. I had to remove it to put my mugen HS on and when I put it back I was worred about the bending it looked very odd.
 
the socket 1366 latch definitely required more pressure than i was used to applying. i didn't notice any bending/bowing though. i was a little worried when i was putting everything together... but it's been running fine for about a month now.
 
the socket 1366 latch definitely required more pressure than i was used to applying. i didn't notice any bending/bowing though. i was a little worried when i was putting everything together... but it's been running fine for about a month now.

same here. It seemed much worse than the 775. I started to push down the lever and then stopped because I was really afraid I messed something up or the cpu wasn't seat correctly. All was well so I just pushed it down till it latched and it's A'ok.
 
yea mine is running great but man i sure had to press hard, and like i said there is a slight bow in the bar. I dont want this thing popping off on me LOL. Though i guess its not going anywhere with a coolermaster v8 boleted down on top of it.
 
It might be because, 775 has many less pins then 1366 and those extra pins are just causing more resistance to the processor being pushed down on them. Thats my guess anyway. It should be fine =)
 
Back
Top