• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

SNT-Systems Aquagrafix Rev 2 Question

S

Stealth5325

Gawd
Joined
Dec 27, 2000
Messages
693
Someone has to know this, and I'm pretty sure I can't be the first guy to ask this question.
I really like the Aqua-Computer Aquagrafix cooler for my 6800GT. I only have two questions on modability, and one on design.
1) I need 1/2" barbed fittings. Are those 'elbow adapters' at the page bottom barbed? Are they for this cooler?
2) I need the inlet/outlet ports facing different directions. I have a K8N Neo2 Platinum, and my water loop goes GPU-CPU-NB, so I'd need the inlet to be facing down (Like the two ports are in the picture), while the outlet faces the opposite direction, up toward the CPU. Can this be done? Do those elbow fittings screw in so I can just adjust to my heart's content?
3) There seems to be a small attached part that would cool the voltage regulators (by the power plug) on this cooler. Am I correct?

Thanks!
 
I like AquaComputer stuff, but I think using this block that was intended for 1/4" will become a serious restriction in your loop.

I am guessing the elbows will swivel, but they are probably 10mm~3/8" barbed
 
Ah! I did not know that. A 1/4" block in my 1/2" loop with my pump will cause a bit too much pressure in the block. I'm concerned about that. They don't have a larger channeled block, do they?
 
1) I need 1/2" barbed fittings. Are those 'elbow adapters' at the page bottom barbed? Are they for this cooler?
Click to expand...

No idea Dan would know for sure.


I need the inlet/outlet ports facing different directions. I have a K8N Neo2 Platinum, and my water loop goes GPU-CPU-NB, so I'd need the inlet to be facing down (Like the two ports are in the picture), while the outlet faces the opposite direction, up toward the CPU. Can this be done? Do those elbow fittings screw in so I can just adjust to my heart's content?
Click to expand...

Yes they can move to your heart's content but I don't know if you have the choice of bent or strait ... I got bent.


3) There seems to be a small attached part that would cool the voltage regulators (by the power plug) on this cooler. Am I correct?
Click to expand...

Yes you are correct. Watch it so you don't bent the card (has I did :( )

I looked for some help and all but didn't find anything for my BFG 6800GT ... the RAM module at the lower right (could be left ... anyway) didn't fit right and I ovescrewed the card :( ... it still works but the temps are high .... 54 idle 58-59 load.
 
You must log in or register to reply here.
Back
Top