SM Capacitors On Video Cards

md262626

[H]ard|Gawd
Joined
Jul 8, 2003
Messages
1,259
I have an older Abit OTES Ti4200 video card sitting in the closet not being used. When I last removed it it was working perfect, but upon removing it from the m/b I snapped off a capacitor. Specifically a surface mount 1000 mf, 6V capacitor. One of the legs (positive side) snapped off. Since the capcitor in question, was surface mount and had no thru holes my question is this:

Has anyone ever tried a regular thru hole cap and just bent the legs perpendicular to the body and just soldered them to the solder pads on the circuitboard? If you've ever looked for SM caps you know they're next to impossible to find. This should work. I'd like to give this card to a friend whose using a GForce2 440 MX. It would be a good upgrade for him.
Any feedback will be appreciated. Thanks!
 
as long as the normal "barrel" type capacitor is the same specs, you shouldn't have a problem as long as you are careful soldering. Do like you mentioned and bend the legs perp to the board (actually, a decent L shape would work very well) and solder to the pads for the smt cap.

otherwise, you can probably order an smt cap from mouser real cheap. Don't order from digikey unless you plan on ordering at least $20 of stuff to begin with (they charge you a "surcharge" for not ordering at least $20).
 
Thanks, I'll give the regular through hole cap a shot first since my local electronics shop has them in abundance. If that doesn't work out I'll give ordering a shot.
 
nst6563 said:
good luck with it. Hope it turns out.


Thanks my brother! I'm pretty sure it will be fine. Like I said initially, it was working perfectly before my fat fingers snapped off that SMT cap :eek: Thanks Again!
 
Back
Top