Slave not functioning?

D

Dps

Weaksauce
Joined
Apr 2, 2005
Messages
72
I have 2 hard drives in my 2nd pc which I installed today.

a 18 gb seagate
and a 20gb wd

I have the jumpers on the WD set up as a slave and the jumpers on seagate as a master..

I put the middle grey cable on the seagate and the end of the ide cable the black one on the slave.

If i switch it around the computer beeps repeatedly and does not boot


I'm running intel p3 800mhz
768mb ram
via motherboard

the slave WD hard drive is recognized in DEVICE MANAGER but in my computer it does not show up..

I reformatted the HD's and I deleted both partitions and only installed windows on the seagate. What should I do and how do I fix this to make my WD a permanent working slave? thanks guys
 
11va1.jpg

28ip.jpg
 
yes, and when the comp loads it recognizes it too,

I do not know how to FORMAT a drive without deleting the partition and reinstalling windows, I know that HAS to have something to do with it
 
You must log in or register to reply here.
Back
Top