Should i consider this SAS3g JBOD?

stevebaynet

Limp Gawd
Joined
Nov 9, 2011
Messages
204
Need a sanity check.

New ZFS SAN uses SAS6g SC847 JBOD. However, this system will be HA between two head nodes. I have Stec enterprise SSD (ZuesRAM) ZIL for production bits, but i dont want to have to buy a $3k drive everytime i want to make a new pool that isnt critical or production.

I'd like to be able to use cheaper SSD's for less important stuff. but because of the dual node setup, consumer SSD's wont work unless i use an interposer. interposers wont fit in the SC847 drive sled !#@#%^

(+im told puting the zil in the head nodes would be a no no since it wont carry over to the other node on failover)

I can get one of these for cheap locally:

http://www.dataonstorage.com/dataon-products/dns-1200-2u-sas-to-sassata-jbod-storage.html

Its 3g SAS and its "end of life", but again, its got redundant parts and im not putting critical stuff in it. Mainly, i would get the sleds with interposers and throw a bunch of SATA SSD's in it. (some for zil/slog, some for l2arc)

Also, specs say:

"One SAS I/O Module (SIM) supports two SAS 3G wide ports" (it will have 2 of these)

"Dual wide port capacity supporting up to 2,400MB/s"

Thoughts?

Yay? Nay?
 
That's pretty pricy considering $/drive and the recent deal some of us got in on as described here: http://hardforum.com/showthread.php?t=1666401

Agreed, i nearly drove down there and bought a few of those myself. However, these have redundant PSU's and my plan was to buy two (two for one $$) and put the SAS module from the second into the first. So i had 1 JBOD with redundant PSU, and redundant SAS with multi-path. This would have worked for the HA build i was working on, where the rackable one would not have.

Ultimately, i wanted to stick with SAS6g so i decided not to do it.

Mainly just throwing this out there in case someone else seemed interested. They seemed extremely willing to bargain for the remaining 4 units they had.
 
Back
Top