Seagate Drives : Major power consumers?

Laforge

2[H]4U
Joined
Jun 29, 2003
Messages
3,132
Reading seagates white sheets on everything from their ata-100 40gb 5400 rpm drives and up, I'm surprised to see that they say 2.0 A and HIGHER [2.8A] is the load needed to run their drives.. Now, I don't want to really use maxtors anymore, but, at 662mA [.67A] for THEIR drives under load, .. something seems wrong here.. To me, 2.8Amps to run a harddrive seems like a lot, no?
 
That's peak draw, like at spinup. They don't always draw that. If you look at the "watts" figures below that, it's actually only drawing half an amp or so while writing. Or maybe I'm talking out of my hat?

Next time a link to the whitesheet would be nice.
 
unhappy_mage said:
That's peak draw, like at spinup. They don't always draw that. If you look at the "watts" figures below that, it's actually only drawing half an amp or so while writing. Or maybe I'm talking out of my hat?

Next time a link to the whitesheet would be nice.

You wear a hat? Actually I think your right, big amps on startup, far fewer while running. Somthing that needs to be takken into account when buying a PSU ;)
 
unhappy_mage said:
That's peak draw, like at spinup. They don't always draw that. If you look at the "watts" figures below that, it's actually only drawing half an amp or so while writing. Or maybe I'm talking out of my hat?

Next time a link to the whitesheet would be nice.


+12 VDC +/-10% (amps typ operating) 2

Doesn't that mean

"Typical Amps Used during operation?"

2.0?
 
I have my controller init the spin up of my Cheetahs to lessen the shock on the PSU on cold starts.
 
WS6 said:
I have my controller init the spin up of my Cheetahs to lessen the shock on the PSU on cold starts.


Yeah, but I can't do that on barracuda's, can I?
 
Laforge said:
Yeah, but I can't do that on barracuda's, can I?

If they are not SCSI, then I don't think so. I can do delayed start or controller init on my SCSI Barracudas.
 
Only SCSI's can do a delay start, I have 14 of them in my server and the HBA spins up 2 at a time every 6 seconds to reduce the load.

The 2 amps for those Seagates would be when they start, somewhere on their datasheet you should see a typical and idle power consumption which is usually around half an amp.
 
tdg said:
Only SCSI's can do a delay start, I have 14 of them in my server and the HBA spins up 2 at a time every 6 seconds to reduce the load.

The 2 amps for those Seagates would be when they start, somewhere on their datasheet you should see a typical and idle power consumption which is usually around half an amp.
From the 3ware Escalade 7506 datasheet:
Staggered spin-up to minimize in-rush current at power up
So if you're lucky enough to have a 3ware controller, it supports staggered spinup somehow.
 
unhappy_mage said:
From the 3ware Escalade 7506 datasheet:

So if you're lucky enough to have a 3ware controller, it supports staggered spinup somehow.

I know our (maxtor) new ATA drives have this feature on them to be able to support staggered spinup. Only on some firmware revisions though. Not entirely sure which ones. You change a jumper setting on them, and they are able to do it. Its kind of neat to be able to do with ATA drives finally...
 
Back
Top