SCSI question about drives in win XP

tmarshall

Limp Gawd
Joined
Nov 19, 2003
Messages
395
I have an old Dell Server (4200) with (6) 9.1 Gb Seagate LC drives.

The SCSI card is a 2940.

The question:
Only 5 of the drives show up in My Computer. Why?

I have formatted all the drives in WinXP, except the one that doesn't show in Drive Managament.

But all 6 show in Device Manager.....?
 
Try getting the drive to recognize with no other drives on the chain, check the id's and everything
 
Go into the SCSI card bios. Its Control A on Adaptec cards. Then see if there are any conflicts on ID numbers. If the drive isn't seen in the SCSI bios it won't be seen by windows eather. Also do a verify on the drive to make sure it is good if you see it in the SCSI bios.
 
Have you tried a verify and/or low level format in the SCSI bios?

I assume that since you've got 6 & they're LC models you're using a hot-swap backplane, so unless there's other suff you've patched into the bus you should be fine on SCSI IDs.
 
I am using a swappable backplane. Kudos!

All the Drives have their own ID's.
No conflicts.
All are shown in device manager.
Only five are shown in Disk Management.

And, yes, All show in the SCSI BIOS even the Dell Backplane.
 
Have you tried disconnecting the other drives to see if this drive even shows up at all by itself, just to make sure it's not dead altogether?

Is the drive trying to take a drive letter that is in use by another (local or network) drive?
 
Since you can see the drive but can't access it, I'd try a low level format from the SCSI bios. Perhaps it's grown a bad sector in a bad place or is badly corrupted. A low level format should get the drive to remap any bad sectors and will (obviously) clear any bad data.
 
zandor said:
Since you can see the drive but can't access it, I'd try a low level format from the SCSI bios. Perhaps it's grown a bad sector in a bad place or is badly corrupted. A low level format should get the drive to remap any bad sectors and will (obviously) clear any bad data.

I've had this exact thing happen with a 18GB Fujitsu.. My LSI BIOS would see the drive and spool it up.. Windows XP showed the drive under "device manager' but not under My Computer or the Manager..

I tried everything in the book; nothing helped.. Different HBA, cables, terminators; nothing.. So I've concluded that the Fujitsu is dead..

So if you low level through your HBA bios and it doesnt' change anything, most likey its a gonner..

Ben
 
Back
Top