• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Replacing a HD controller board?

D

Deadjasper

2[H]4U
Joined
Oct 28, 2001
Messages
2,852
I have a 6TB HD with a busted connector. If (I know it's a big if) I can find the same board can I just replace it and the will it work properly? Data on the drive is of no concern.

TIA
 
In order to get a donor board, you're going to acquire a whole drive, which will likely be fully functional. At that point, you'll have a fully functional drive, so again, why bother swapping it over, possibly damaging the board in the process, possibly finding the board swap doesn't work, if you don't care about the contents?

Just buy a new drive and move on with your life. And maybe stop doing whatever caused the connector to get busted.
 
Deadjasper said:
I have a 6TB HD with a busted connector. If (I know it's a big if) I can find the same board can I just replace it and the will it work properly? Data on the drive is of no concern.

TIA
Click to expand...

Maybe? My concern would be that the board stores unique info about the particular unit that it shipped as a part of, and moving it from that to another set of platters would result is weirdness.

If the connector is broken, I'd think a better option would be to bust out the soldering iron just replace that. Digikey and similar sites may sell such connectors. Even then I'd personally only do it to get any needed data off, and then trash the drive.
 
You must log in or register to reply here.
Back
Top