I just built the following specs yesterday and am having some critical issues everytime I try to run a 3D app:
CHAINTECH VNF4/Ultra Socket 939 NVIDIA nForce4 Ultra
AMD Athlon 64 3000+ Venice
Kingston ValueRAM 1GB (2 x 512MB) 184-Pin DDR 400
Sapphire X800 Pro w/ Cat 5.7
Windows XP SP2
Antec TruPower 430W
1 120mm fan and 1 80mm fan
I've tried running a few benchmarks to see how things are running, but at any point within the first two minutes, the system either reboots without notice or closes the app due to a critical error. I receive no prompt or notification after the comp reboots, as if nothing happened in the first place. Up until running any sort of 3D app, I haven't run into any problems -- even Prime95 has been running without a hitch.
My main concern is my 430W PSU because it's about two years old and has the 20-pin connecter rather than the 24-pin one. I've heard from a lot of people with my same PSU who've managed to run their setup flawlessly. I haven't been so lucky.
I tried to update the BIOS and whatnot, but the motherboard is new enough that they don't have any new versions, I think. Chaintech's website is primitive at best. I've tried both ATI's and Omega's 5.7 drivers, both to no avail. I'm kind of at a loss. Any help would be deeply appreciated!
CHAINTECH VNF4/Ultra Socket 939 NVIDIA nForce4 Ultra
AMD Athlon 64 3000+ Venice
Kingston ValueRAM 1GB (2 x 512MB) 184-Pin DDR 400
Sapphire X800 Pro w/ Cat 5.7
Windows XP SP2
Antec TruPower 430W
1 120mm fan and 1 80mm fan
I've tried running a few benchmarks to see how things are running, but at any point within the first two minutes, the system either reboots without notice or closes the app due to a critical error. I receive no prompt or notification after the comp reboots, as if nothing happened in the first place. Up until running any sort of 3D app, I haven't run into any problems -- even Prime95 has been running without a hitch.
My main concern is my 430W PSU because it's about two years old and has the 20-pin connecter rather than the 24-pin one. I've heard from a lot of people with my same PSU who've managed to run their setup flawlessly. I haven't been so lucky.
I tried to update the BIOS and whatnot, but the motherboard is new enough that they don't have any new versions, I think. Chaintech's website is primitive at best. I've tried both ATI's and Omega's 5.7 drivers, both to no avail. I'm kind of at a loss. Any help would be deeply appreciated!