ran memtest... recieved errors... now what?

AP2

[H]ard|Gawd
2FA
Joined
Jun 25, 2007
Messages
1,570
i just ran memtest for the first time and have no idea what the value means. can anyone help interpertate what they mean? also, do i need send these back.

memtest for 4x1GB dominator 8500c5d over a 9hr period.

test: 6
pass: 3
failing address: 0006D6085F4 - 1750MB
good: FFFDFFFF
bad: FFFD7FFF
err-bits: 00008000
count: 10

photo.jpg
 
Since your running 4 sticks at once. I'd try upping your memory voltage one bump maybe two and try again. Also searching for that EXACT ram and what others are doing with 4 sticks + voltage, etc. would help! :p

PS: I just checked on newegg quick and their reviews. Are you running the required 2.1 volts on the ram? If so then try 2.2 volts and run memtest again.
 
Well, if you found errors, you need to try to get rid of them. :)

I just went through nearly the exact same thing, errors during test 6 of Memtest. Here is the thread at OCZ. http://www.ocztechnologyforum.com/forum/showthread.php?t=32942

To check and make certain the number of RAM slots isn't the issue, as well the RAM itself isn't the issue, try 1 stick, first in one of the pairs of slots, and then the same stick in the other pair of slots (usually RAM slots are two colors, each color indicates the pair to be populated).

First off, 9 hours on Memtest? Waste of time, even the original creator of the program says so. http://www.memtest86.com/tech.html "Generally a single pass is sufficient to catch all but the most obscure errors."

Check Corsair's forum http://www.houseofhelp.com/v3/showthread.php?t=54052 they indicate the maximum voltage for your RAM is 2.20 V. I also have 2 x 1 GB sticks of Corsair, but of the non-Dominator variety and 2.20 V is fine.

Which motherboard do you have? Do you have the latest BIOS?

The error you get is mainly caused by the tRAS timing, as indicated here: http://www.ocforums.com/showthread.php?t=409152

Once you have that, the first and easy thing to try is, as Tazman2 stated, make certain the voltage is correct. If that doesn't cure it, increase the timings. Since the tRAS may be the culprit, increase that value. If that doesn't do the trick, increase all of the timings, for example, if the timings are 5-5-5-15, try 6-6-6-18.

From this point out, don't bother running all of the tests in Memtest, just test 6, it will save you a whole bunch of time. Just press C to configure, then 1, 3, 6, ENTER, 0 (going from memory, but I believe those are the correct key presses).

Test 6 normally takes 15-20 mins to complete, so hopefully you'll get the error within 4-5 minutes so you can tweak and test rather quickly.

In the end, it may turn out that you can never get that RAM to work with that motherboard, but good luck and post back your results!
 
Back
Top