Quick question

[digital_exhaust]

Well, my son just shut off one of my folding machines. So, my question is, how do I restart work on the wu's that it was working on? I am very close to finishing a couple pretty big ones and I don't want to loose them? Any help is appreicated!!

edit... sorry that was too vague. I'm running two clients on this machine, and when it rebooted, only one client re-started, and I'm not sure how to re-start the other.....

 

[Tigerbiten]

Just start the client as normal.
Unless you are very unlucky then it restarts from the last frame saved.
If your very unlucky then you get a checksum error and it restarts from frame 1.

If it was a bad shut down, ie power loss, etc then you need to check that the SSE boost is turned on.
One way to make sure it is, is to use the -forceasm switch in the shortcut's target line or the sevice start line depending on how you run it.
If the boost is off then just shut the client down and then restart it, that will turn the boost back on.

Luck ..........

 

[digital_exhaust]

Thank you very much. I was just a little nervous doing that without knowing that was the correct procedure.

Thanks again!!

 

[Team Obi Juan]

Is this the best place to do that forceasm and advmethods stuff?

Please respond cause I'm going out of town tonight and this will be folding without me here for a week.

If not, how do I stop the service, add those lines and then restart the service?