Quick Disconnects...

[nodle]

Can someone tell me if these are the correct part number and fittings? I think I have them worked out...

I think these are the part numbers for the 3/8" stuff...

60813 3/8" Polypropylene Hose Barb Shutoff - 1.86 Lgt - Coupling Insert

60694 3/8" Polypropylene Bulkhead Panel Mount Hose Barb Shutoff- 2.82 Lgt - Coupling Body

And for the 1/2"...

60814 1/2" Polypropylene Hose Barb Shutoff - 1.86 Lgt - Coupling Insert

60695 1/2" Polypropylene Bulkhead Panel Mount Hose Barb Shutoff- 2.82 Lgt - Coupling Body

Maybe someone can tell me if I am correct?

Also does anyone know the diameter of the holes that would need to be cut or drilled for the 3/8" ones?


Link to site... http://www.usplastic.com/catalog/pr...egory_name=6917&product_id=7413&cookie_test=1

 

[Bio-Hazard]

Those look like the correct fittings............ The half inch are the same ones I used anyways. If I remember right, the 1/2 inch and 3/8 inch use the same size mounting hole for the pannel mount, 1.25 inches I think.

"Panel thickness .030" to .25", 1.20" diameter mounting hole 1.87" minimum coupling spacing Greenlee 730K--3/16 Keyway Punch Unit and 730S Hole Punch"

 

[nodle]

Those look like the correct fittings............ The half inch are the same ones I used anyways. If I remember right, the 1/2 inch and 3/8 inch use the same size mounting hole for the pannel mount, 1.25 inches I think.

"Panel thickness .030" to .25", 1.20" diameter mounting hole 1.87" minimum coupling spacing Greenlee 730K--3/16 Keyway Punch Unit and 730S Hole Punch"

Thankyou sir!

 

[mrgstiffler]

I almost got those when I was doing my setup. But, I couldn't justify the almost $40 that it costs...

 

[nodle]

I almost got those when I was doing my setup. But, I couldn't justify the almost $40 that it costs...

What did you go with then? I wish there were other ones like them that would do the same just cheaper...

 

[mrgstiffler]

I just got couplers with hosebarb ends. As seen here: