• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Question about WC and fill lines.

J

JelloBiafra

n00b
Joined
Jan 11, 2005
Messages
27
It says I should put the T for the Fill Line at the lowest point in the circuit. The problem I've encountered is that the lowest point in the circuit on my system is right infront of the out for my pump. Is it safe to put the T right after the output of the pump or will that diminish the flow?
 
put the T line on the inlet of the pump. even if that is not the LOWEST point in the loop, given that the outlet is at the lowest point, the inlet should still be pretty close to the bottom.

keeping the T close to the pump inlet puts it where it will do the most good at feeding the pump a steady supply of water.
 
If you do not have a res you should put it right before the pump. Pumps are most often not self-priming. If you do not do this, then you will have a very difficult time getting water to flow.
 
You must log in or register to reply here.
Back
Top