Question about my 12v 4pin

lil layzie

Gawd
Joined
Jan 7, 2004
Messages
755
I bought a new corsair psu (CX430) to power my old amd64 system.

My motherboard is an DFI Lanparty UT nF3 250GB.

The problem with this power supply is it doesn't have a 4pin 12v wire to connect to my mobo. I just wanted to see if my comp would still power up and it did.

Here's the top half diagram of my mobo
sV4o3.jpg


Where the red arrow is pointing is where I dont have anything connected to it.

Since my computer still turned on without the connector, is it safe to run the comp without it? or should i just go and get something like a molex to p4 adapter?
 
If you look at the 8-pin EPS connector, it should split in two to make the connector you need.
 
lol ok I'm an idiot, i didn't realize the eps connector split like that.

i turned off my comp to check the connector and it was able to be snapped off to fit into the p4 connection.

i guess i was just excited to connect my new psu to my comp overlooking that small detail.
 
Back
Top