• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Question About Controling Multiple Hard Drives With Multiple RAID Controllers

V

Vapor1000

[H]ard|Gawd
Joined
Oct 8, 2004
Messages
1,049
hello,
i just set up my hard drive in a different setup...
my Promise FastTrak S150 TX2 Plus SATA + ATA100 RAID Controller arrived today...
prior to recieving this RAID Controller, i have been running 2 of my ATA hard drives on a Promise Ultra 100 TX2, 1 ATA Drive on my Epox 5EPA+'s onboard ITE IDE RAID Controller which will house up to four drives, and my 4 SATA Raptor Drives on my Onboard SATA controller...
in that old configuration, i had no problem seeing any of my drives... all of them were seen and worked 100%.

but now with the new setup with the SATA+ATA Raid Controller card, it will see and utilize in windows my 2 74 raptors i put on it, because it put them in a raid, however... the controller sees the other 2 320gb drrives but does not see them in windows... then my 250gb drive that i have pluged in single into my onboard ITE does not even get recognized... i have it enabled in the bios, but since i installed this card it no longer goes thru its detection process when the computer first boots up... and windows still sees the ITE controller under device manager, but when i click on its manager program, when it used to say it found a 250GB drive, it now says no drives.. when that drive is still pluged in....

so basicly... what do i need to do to get my 3 ATA100 drives working again without putting them into a RAID setup....

plz help.... thanks... Vapor
 
ok... so i solved the problem of the 2 ATA 320gig drives on my S150 TX2 Plus not showing up in windows by making them both single drive stripes.... and i didnt lose any of my data that way eather :D .
but ive still got my 250gig ATA that is not being detected by my ITE onboard IDE RAID controller...
 
I've had issues before with multiple RAID/SCSI/SATA controllers in that since there is only a limtied memory space for add-on BIOSes like that, one or more won't work. Try updating all the firmware, and if possible move the single drive over to the old UATA controller
 
You must log in or register to reply here.
Back
Top