--------------------------------------------------------------------------------
In the BFG website says the requirements for psu is A minimum 400W system power supply (with 12V current rating of 20A or more). I have 400W psu but I have +12v=/19A will that be enough ?
This is my psu spec just in case
Maximum Power true 400W
Hold-up Time 16ms minimum with full load 115 VAC/60 HZ
Efficiency > 70%
Over Voltage Protection +5V: 7V Max./ +3.3V: 4.5V Max./ +12V: 15.6V Max.
Input Voltage Manual Selectable (90Vac ~ 132Vac/ 180Vac ~ 264Vac)
Input Frequency Range 47 - 63Hz
Output +3.3V@25A/ +5V@32A/ +12V@19A/ [email protected]/ +5VSB@2A
MTBF >100,000 Hours
Certified by: IEC950, UL1950, CSA C22.2 NO.950, EN 60950, CCIB, BCIQ, CE
This power unit has (1) ATX P1 20pin connector, (1) ATX12V P4 Connector, (7) peripheral power connectors, (2) floppy drive connector.
Dimensions: 5.9 W x 3.9 H x 5.5 D - Inches
Will this be enough ? TY
In the BFG website says the requirements for psu is A minimum 400W system power supply (with 12V current rating of 20A or more). I have 400W psu but I have +12v=/19A will that be enough ?
This is my psu spec just in case
Maximum Power true 400W
Hold-up Time 16ms minimum with full load 115 VAC/60 HZ
Efficiency > 70%
Over Voltage Protection +5V: 7V Max./ +3.3V: 4.5V Max./ +12V: 15.6V Max.
Input Voltage Manual Selectable (90Vac ~ 132Vac/ 180Vac ~ 264Vac)
Input Frequency Range 47 - 63Hz
Output +3.3V@25A/ +5V@32A/ +12V@19A/ [email protected]/ +5VSB@2A
MTBF >100,000 Hours
Certified by: IEC950, UL1950, CSA C22.2 NO.950, EN 60950, CCIB, BCIQ, CE
This power unit has (1) ATX P1 20pin connector, (1) ATX12V P4 Connector, (7) peripheral power connectors, (2) floppy drive connector.
Dimensions: 5.9 W x 3.9 H x 5.5 D - Inches
Will this be enough ? TY