• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Push-Pull fan recommendations for Xigmatek S1283

M

Markistehnamezor

Gawd
Joined
Jun 16, 2008
Messages
808
What are the best pair of fans to put on a xigmatek S1283 for a push pull config?

I was looking at the Scythe S-flex 63.7 CFM @ 28db as my choice.

But opinion from others matter to me also on this set up.

Thanks,
Mark
 
Unless he duct tapes it. OP didn't set any parameters for a fan either - quiet? don't care? just want as much air as possible?
 
Actually, I think a push pull config would only benefit if you were using fans that create little air-pressure. You'd be better off getting a single 38mm by 120mm fan. Scythe makes one in 1000, 2000, and 3000 RPM increments. The 1000 is pretty quiet and can push a decent amount of air for it's quietness. Dba measurements are around 19 to 20.

As another has said, you didn't say what type of fan you wanted. You want a screamer? something silent? A good mix?
 
I have the Noctua fan on my Xig just for push, and it works very well. Great CFM/DBA
 
You must log in or register to reply here.
Back
Top