this is just a quick question, but i wanted to know which OD fitting size of this pump, http://www.dangerden.com/mall/Pumps/dd12vd4.asp, i should get to work with 1/2" ID & 3/4" OD tubing.
Thanks
Thanks
![[H]ard|Forum](/styles/hardforum/xenforo/logo_dark.png){kind=logo}
Navigation
Install the app
How to install the app on iOS
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
More options
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Pump OD size
- Thread starter linger
- Start date
I have the same pump, but from Swiftech.
The actual OD of the Inlet and Outlet is 5/8", but you'll want to use 1/2" ID tubing to go over it to make sure you get a tight fit.
Just warm up the end of the tube in hot water and slip it on there. It's not too hard.
Anything smaller than 1/2" ID tube will be a bitch to put on or just plain impossible.
The actual OD of the Inlet and Outlet is 5/8", but you'll want to use 1/2" ID tubing to go over it to make sure you get a tight fit.
Just warm up the end of the tube in hot water and slip it on there. It's not too hard.
Anything smaller than 1/2" ID tube will be a bitch to put on or just plain impossible.