Project: Transfusion

[Justin_Diduch]

ok here is the beginning on my next project. just got another heatercore at autozone. this one is part#39 9078 eg the fedco 2-302. so far i've just put the barbs on. still needs to be bondo'd and painted once it all cures. i also added a little magnum weld for added strength and to bulk the tubes up a bit to hide the transition. the bondo will finish that off.

right now the case is in use for paper mockups and such. i will post pics of the skeleton next time i strip it down.

 

[Justin_Diduch]

OK, this case was given to me by a friend. one day he called me and said he had a present for me. (it was already hacked on a bit and he thought i could save it) so here is an old pic of the case the way i got it. (pretty weak huh?)

here is what i have gotten pics of so far... bear in mind, all of this is just rough fitting and mock-up.
rad test fit...

rear view, no mobo tray...

shot of the new intake grill and switch/usb/1394 panel (no its not going to be yellow!)

close up of intake...

and some progress shots on the radiator...

 

[Hard911]

what a giant case you got there!

 

[1337m0dd3r]

damn thats a beast of a case.. 8) Can't wait to see what all you do with it.. looks good so far

 

[skudmunky]

looks good, can't wait to see how this turns out.

 

[Majin]

You should give that Core a bath in a tarnish remover. That way it will SHINE in all it's Copper glorry!

 

[Justin_Diduch]

bah all the copper is getting painted. the industrial look aint me. red n black i think....