images are clicky
Following steps from this mod ShinyShuttle. I'm doing the same with my Lian-Li V1100 Plus II.
I'm also adding an Antec Big Boy 200 200mm fan as a bottom intake and as a side exhaust. link
(pics are worth a 1000 words)
Stock Lian-Li 120mm vs Antec Big Boy 200
Obligatory "before" pics
(after removing the computer components and everything in the case that was screwed down)
(cutting of hole for bottom intake fan, 3M painters tape used for fan outline)
(dremel got away from me a few times
(mobo/psu divider would block air rendering bottom intake useless, chisel and hammer used to remove them)
(dremel wire brush used to scrape away anodization layer, didn't take long for me to realise some bigger was needed)
(orbital sander used after realising how long its gonna take with a regular 1/4 sheet vibrating sander is going to take)
(wet sanding with 400 grit)
Tonight I've schedualed more wetsanding 800 grit (and greater) and hopefully I can get around to using this stuff this comming Saturday.
Following steps from this mod ShinyShuttle. I'm doing the same with my Lian-Li V1100 Plus II.
I'm also adding an Antec Big Boy 200 200mm fan as a bottom intake and as a side exhaust. link
(pics are worth a 1000 words)
Stock Lian-Li 120mm vs Antec Big Boy 200
Obligatory "before" pics
(after removing the computer components and everything in the case that was screwed down)
(cutting of hole for bottom intake fan, 3M painters tape used for fan outline)
(dremel got away from me a few times
(mobo/psu divider would block air rendering bottom intake useless, chisel and hammer used to remove them)
(dremel wire brush used to scrape away anodization layer, didn't take long for me to realise some bigger was needed)
(orbital sander used after realising how long its gonna take with a regular 1/4 sheet vibrating sander is going to take)
(wet sanding with 400 grit)
Tonight I've schedualed more wetsanding 800 grit (and greater) and hopefully I can get around to using this stuff this comming Saturday.