• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Problems with top mounted rad???

T

Teecee

Gawd
2FA
Joined
May 31, 2005
Messages
948
I am getting a Lian Li G70 case with a 120.3 rad mounted inside on top of the case. I will also have a fill port at the top of the case. I do plan to use a resorvoir. Will I have problems with keeping air out of my loop and keeping my rad full of liquid due to the rad being mounted on the top of the case?

I got to thinking that since my rad will be towards the top of my loop, my res. will fill up leaving my rad with less liquid.

Any thoughts?
 
No.

Once your loop is filled with fluid (which you do by rotating your case and flipping it around to get the air out), it will continue to draw fluid (as needed) from the reservoir.

However, if you are gonig to put a fillport on your PC, why not just do a T-line instead of a reservoir? It will cut down on space, act as your reservoir, cost less, AND be the highest point in your loop.
 
You must log in or register to reply here.
Back
Top