problem with ds3 and e6300

C

c0x

n00b
Joined
Jan 16, 2006
Messages
32
so just got my new parts installed and up and running the past week, wanted to try and get it up to around 2.7, 2.8.

Dropped into bios today and start small bumping up fsb to 280 from 266. I save to cmos, comp restarts and nothing, everything turns on, fans and all, but just a black screen. No mobo beeps, nothing going on. So i clear cmos, and try again. Same thing.

anyone know what the problem could be?


e6300
gigabyte 965P-DS3
2x 1GB OCZ DDR2 800
BFG 7600gtoc
 
Before you increased the FSB did the computer work as usual???? All drivers, etc were installed??

I'm assuming you installed a clean OS (which one by the way?)

Take out the battery and reset the BIOS jumper and see if the computer starts in default.

If that doesnt work you probably have a short or faulty connection and need the start from scratch adding one component at a time outside the case. If that works, reinstall.

Read Bill Parrish's DS3 overclocking guide once you get the thing up and running, it is very complete.
 
well like i said ive had it up and running for the past week. Clean OS install, has worked perfect. But went to start OC today and this happened. I did clear cmos, worked fine, running at default now without a problem.

I'll check up on that guide to see if it can help out any, thanks.
 
changed nothing. Just went in to bios, and unlocked the fsb. Set it to 280, up from 266, and would just boot to a black screen.
 
you need to disable a few things
1. Disable ‘AI Tuning’ for ASUS, ‘C.I.A.2’ for Gigabyte
2. Set PCI Express (PCIe) frequency @100Mhz (‘Auto’ for DS3/DS4/DQ6)
3. Set PCI frequency @33Mhz
4. Disable Hyperpath 3 (for P5W DH only)
5. Disable any ‘spread spectrum’
6. Disable Q-Fan (for ASUS only)
7. Disable ‘Limit CPUID Max to 3’
8. Disable any overvoltage protection
9. Disable ‘C1E’
10. Disable ‘EIST’
11. Disable Virtualization Technology
12. Disable No-Execute Memory Protect
13. Disable any other thing you don’t use
14. Do not enable any speed enhancements you see
 
thanks moddest, were a few setting in there i hadnt disabled. Seemed to do the trick, time to work my way up.
 
You must log in or register to reply here.
Back
Top