Problem.. new PC boots up but screen won't post.

SofaKing

[H]ard|Gawd
Joined
Nov 27, 2004
Messages
1,137
here's my setup:
ECS N2U400-A Mobo
AMD Sempron 2200+ Thoroughbred
1 stick of Mushkin 512 MB PC 3200 RAM
Seagate 80 GB 7200 RPM drive
Antec Smartpower 300 watt PSU
Lite-on 16x dual layer dvd burner
Asus 64 MB Geforce2 MX400

Computer boots up, but nothing shows up on the monitor. I'm sure it's nto the videocard's problem because i JUST got an rma replacement for that.. also the PSU is brand new and i doubt it's the PSU's problem. IT boots up , fans run and all but just nothing shows up. What could be the problem? Please help me out! Thanks in advance. Also there's no bios beep whatsoever. I'm suspecting it's a problem with my CPU.. cause that happened to my previous build when a few pins were bent, but my CPU is brand new so I'm not sure about that. ANy help will be appreciated!
 
yeah, ive had this problem before, and yes, it was a processor problem
make sure that your processor seated correctly in the socket and the heatsink is making good contact
edit: when i had my problem it threw some beep codes
you getting any?
 
siliconcenturion said:
yeah, ive had this problem before, and yes, it was a processor problem
make sure that your processor seated correctly in the socket and the heatsink is making good contact
edit: when i had my problem it threw some beep codes
you getting any?
i'm quite sure my cpu is seated correctly in the socket.. just not quite sure if the heatsink was put on the right way.
 
Take the RAM out, if it faulty and doesn't work it won't start the computer, nor will it beep. If you take it out and the motherboard doesn't beep, then you can rule RAM out.

Leaving the RAM out, take the CPU out. Again, it should beep a lot and complain to you about the lack of a CPU. If it doesn't beep, you may have either a mobo problem or a PSU problem. If it gets to this stage, then you should try to find another PSU to test it and rule it out.

Use this step-by-step approach to rule out each component to finally isolate what is wrong.

Oh and make sure you have a PC speaker attached, otherwise you won't hear any beeps at all :)
 
Back
Top