Possible NF7-S v2.0 FSB problem

Swat

[H]ard|Gawd
Joined
Dec 25, 2002
Messages
1,186
Well , more of a solution hehe. When I have CPU Interface Enabled I'm only able to push my Mushkin lvl2 p3500 to 214fsb at most 1:1. I was getting frustrated because I've heard such good thinks about BH-5. I decided today to changed the CPU interface to disable and see what I could get. Right now I'm running 10x231 @1.8v and my memory is at 2.9v running timmings of 2.2.2.11. No problems and everything including prime are running solid. Maybe this might help some people out that can't overclock thier ram much on the Abit board.
 
10x331! hot DAMN!!! just kidding - I think you've got a typo in there bud.
 
When you disable that setting I also believe that you lose some performance in sandra. Just a heads up.
 
Setting "CPU Interface" to enabled is to enable overclocked cpu parameters, so of course setting it to disabled is going to lose some performance (a small amount at that :rolleyes: ), but you also lose stability. I couldn't even get prime95 to be stable any higher than 210 with cpu interface enabled... but with it disabled I hit 220x10 prime stable... and 235x10 as well (windows stable but not prime stable)
 
I havn't noticed any performance loss in Sandra , actually saw a big gain.
 
Back
Top