Managed to get to 3.9 ghz. Tried for 4 but windows wouldn't boot. I'll probably try 4 again later and see if I play with some other settings if it will work.
44 C idle, speedfan says its 56 on full load during a benchmarking program on infinite loop.
--------------------------------------------------
This is my first at a cpu overclock that I intend to use full time. When I wanted to build this system it was my intent to only overclock it to 3.6 ghz to begin with and then try a bit higher later on when I get some more knowledge on this.
This was done with:
P5n-e SLI
OCZ DDR2 800 Revision 2 2x1gb - running at OCZ's intended settings of 4-4-4-15
Stock the voltage hung around no more than 1.280
There are some things i've been wondering before. I've never overclocked a cpu by this much, ever, and i've never really played with voltages before. I usually like to run my computers 24-7 is their any danger with the increased voltage and fsb by this much to the cpu? I dont know much but i assume since the temperature idles 38 that it should be fine, unless higher voltages put intense stress on the chip or mb.... that i dont know.
I dont have an accurate temperature gauge except in bios. In Windows i'm forced to use speedfan since nothing else works on this board, lol. If you know of a good one that works on this board i'd be pleased to know.
I'm going to try to push it higher, to 3.8 or even 3.9 or 4.0 if I can after i'm sure this would be ok to run like I intend.
edit: I notice in cpu-z the voltage jumps around a lot, i hope that isn't a problem.
44 C idle, speedfan says its 56 on full load during a benchmarking program on infinite loop.
--------------------------------------------------
This is my first at a cpu overclock that I intend to use full time. When I wanted to build this system it was my intent to only overclock it to 3.6 ghz to begin with and then try a bit higher later on when I get some more knowledge on this.
This was done with:
P5n-e SLI
OCZ DDR2 800 Revision 2 2x1gb - running at OCZ's intended settings of 4-4-4-15
Stock the voltage hung around no more than 1.280
There are some things i've been wondering before. I've never overclocked a cpu by this much, ever, and i've never really played with voltages before. I usually like to run my computers 24-7 is their any danger with the increased voltage and fsb by this much to the cpu? I dont know much but i assume since the temperature idles 38 that it should be fine, unless higher voltages put intense stress on the chip or mb.... that i dont know.
I dont have an accurate temperature gauge except in bios. In Windows i'm forced to use speedfan since nothing else works on this board, lol. If you know of a good one that works on this board i'd be pleased to know.
I'm going to try to push it higher, to 3.8 or even 3.9 or 4.0 if I can after i'm sure this would be ok to run like I intend.
edit: I notice in cpu-z the voltage jumps around a lot, i hope that isn't a problem.