PCI Express x16 or x8???

wes337

n00b
Joined
Jan 14, 2006
Messages
25
I'm running SLI Geforce 7800GT, I was just looking at my Graphics Card information and it says: "BUS: PCI Express x8". I know my motherboard has 2x PCI Express x16 slots... But I'm really confused, did I put the video cards in the wrong slot, or did it divide x16 in half because of SLI? :confused:
 
they run in 8x when you use SLI 16x for single card....unless you have a A8N32 then it would be 16 on both cards
 
The slots run in 8x when there's two cards. A slot will only run in 16x mode when there's only one card.

It's well documented in your manual...
 
This is a normal occurance running SLI. on most N4SLI chipsets(except the SLIx16 one) when you run 1 card there is 16x lanes avalible for use. when you run SLI it cuts them in half to drive each card. Your not taking a bandwith hit using 8x. Most cards can run down to 4x before performace drops
 
Don't sweat it. Your motherboard supports up to 16 lanes, and it works like TheGamerZ said.

All the reviews of NForce4 x16-SLI have not shown any real performace benefits to x16-SLI anyway. There just aren't any apps that use that kind of bandwidth, and by the time they do, current hardware will be very dated anyway.
 
heatlesssun said:
Don't sweat it. You're motherboard supports up to 16 lanes, and it works like TheGamerZ said.

All the reviews of NForce4 x16-SLI have not shown any real performace benefits to x16-SLI anyway. There just aren't any apps that use that kind of bandwidth, and by the time they do, current hardware will be very dated anyway.

QFT

We havnt even matched AGP 8x speeds yet I dont think. I think the current bandwidth that current hardware uses is just maxing out AGP 4x if im not mistaken.
 
Lazy_Moron said:
QFT

We havnt even matched AGP 8x speeds yet I dont think. I think the current bandwidth that current hardware uses is just maxing out AGP 4x if im not mistaken.

Correct, AGP 4x is just barely maxed out.
 
Something else to remember is that AGP was designed when video memory was still very expensive. Now that 256MB cards and up are common, even in low-end consumer cards, the bandwidth requirements may have gone down...instead of swapping stuff in from main system memory as you go along, you can just dump everything into the frame buffer right away and work with it on the card.
 
so PCI-E was brought in solely to force us to upgrade everything?

Its almost a pain in the ass to upgrade now. whats next in a year? AGP-E? :rolleyes:
 
PCI Express is a much more flexible and robust bus. That (and as I posted in another thread when this came up), it "just works" as well. No messing with GART drivers. No messing with AGP speed settings. No tweaking side band addressing/fast writes/aperture sizes. Also, PCI Express was designed from the ground up as a high bandwdith interconnect, rather than as a patched together "hack" on PCI. There were a lot of compromises made to get AGP halfway working, and its a wonder it served as long as it did. However, it needed to be replaced. SLI/Crossfire aren't possible on AGP, neither are HyperMemory/TurboCache. PCI Express is also a boon to users that want more than two monitors.

If you don't care about any of these things, then AGP will work fine for you. I haven't looked back though.
 
Back
Top