anyone using this?
came out earlier this month, but im still on 1014 since its running fine.
does 1015 change anything other than disabling ide drives/usb optimization?
how does it stack up to 1014 overclocking wise?
thx.
I'm using it. IMO it sucks ass. It takes a full 10 seconds to get past the post screen whereas with the previous bios it was maybe half that. All the settings are the same, and overclocking isn't any better/worse.
if you really don't need it...then don't bother. Of course, you can always save your current bios, then upgrade and if you don't like it then re-flash the old one.
not quite sure what you mean. If it's what I'm thinking, Big Toe (don't believe he's on these forums) came up with a hack of flashing the bios with a p48s (or something like that). That would set the boot block as a 533Mhz fsb, which would by default enable MAM/PAT ALL the time...even when the FSB went above 200. After flashing the boot block of the p48s, flash the normal p4p800 bios without the boot block.
however, since I don't have a cpu that breaks the 200MHz barrier yet, I haven't done it.
there's also a droop mod you can do to improve your voltage fluctuations during high cpu load.
does PAT give that much of a performance boost though? caus im not sure if it would be worth it.
i prolly wont end up doing it anyway, in case i mess something up i dont have time to rma a board.
I got this board coming in on Thursday or Friday. Are you guys saying don't bother with the 1015 Bios and just flash it to 1014 if it's not already there?
i already get a long pause on checking nvram lol
using 1014, sometimes it pauses for about 5-7 seconds, sometimes it just goes by quick.
no clue as to why though.