I have a friend who recently purchased an Asus P4P-800 Deluxe and an Intel Northwood 3.0C. Since he recieved the hardware from NewEgg his Asus board has been repeatedly shutting down, and after some checking in the BIOS immediately afterwords showed the CPU temperature being reported at 87 Celc after runing for 45 seconds.
He was using the retail HSF included with the retail CPU and some generic thermal paste. He checked to make sure the HSF was on right, chip settins were correct, etc, and when that failed to help, ordered a new HSF (can't remember what kind at the moment, one of the better Vantec ones) and that dropped his temps to 65C right after boot. Still way to high. When he applied the Artic Silver the temps jumped back up to 73C.
He tested the board while running with an external thermal probe and found out that while the board is reporting rediculously high temps, the probe only called it 39C. Touching the CPU directly after shutting down and removing the HSF (around 30 seconds) leaves the chip only feeling warm to the touch, even though the board reported the chip running at 70+C.
At this point I'm fairly certain that the temp sensor on the board is giving bad readings. Has anyone else ever heard of this and possibly any fixes for it?
He was using the retail HSF included with the retail CPU and some generic thermal paste. He checked to make sure the HSF was on right, chip settins were correct, etc, and when that failed to help, ordered a new HSF (can't remember what kind at the moment, one of the better Vantec ones) and that dropped his temps to 65C right after boot. Still way to high. When he applied the Artic Silver the temps jumped back up to 73C.
He tested the board while running with an external thermal probe and found out that while the board is reporting rediculously high temps, the probe only called it 39C. Touching the CPU directly after shutting down and removing the HSF (around 30 seconds) leaves the chip only feeling warm to the touch, even though the board reported the chip running at 70+C.
At this point I'm fairly certain that the temp sensor on the board is giving bad readings. Has anyone else ever heard of this and possibly any fixes for it?