P4 titan Giga-Byte........

S

Spire_X

Guest
I have 2 of the same boards........the ga-8ipe1000pro rev.1..........when I try and swtich out mobo's to my current sys.....the power turns on but no vid???? just like all the lights come on and stay on....like it's in idle????? I am pulling my hair out on this one....both of the boards do it.....I have a antec 350 trueblue psu and I even tried a antec 400 reg psu.......neither would work......
 
do you get any beep codes or are the fans just running? You may want to reset the BIOS.
 
I took out the batt......for like 2 days lmao....and still nothing and I don't get a beep code.....it is like in idle.....almost like it's not gettin enough power.....but I tried 3 diff power supply's I know one of the boards used to work aleast cuz I had probs tryin to run a celeron on it till I found out it will only run a p4
 
the thing I hate about that damn board is no fucking cmos reset jumper. Just two solder blobs so you have to gank out the battery. Oh that and the fact that when I had the board it decided one day to zap all my pci cards. Took out a 3com gigabit nic, audigy, and a 3ware SATA raid card. :mad: And gigabyte wont rma the board. :mad: :mad:
 
ohhhhh sh*t.............that sux.........I am messin with it now........still have no luck :( even tried diff ram again lol
 
Just had the same problem with an MSI 845PE..... Sounds to me like your processor might have gone bad. That's what the culprit was with mine.
 
Make sure there are no leaking capacitors on the motherboard. Had the same thing happen to an older mobo that I am now packing up to go for RMA.
 
humm I looked....I think the board is gettin power but the cpu is not.....I unplugged the 12v and everything was the same.....it is like the board is not gettin 12v????
 
Have you tried checking the 12V plug with a voltmeter? Sounds like it might be your PSU or even as simple as a loose pin.
 
no I haven't......I have tried 3 diff psu's though.....so it must be sumthing on the boards right?
 
Back
Top