Orthos Blend unstable, small FFT stable

spotpuff

Gawd
Joined
Aug 15, 2001
Messages
522
Trying to OC my E4300. I've got it running at 8x334. Core is orthos stable, however as soon as I switch to blend, Orthos errors out.

The RAM I'm using is OCZ PC6400 Platinum Rev 2; no idea what the actual voltage is supposed to be since the OCZ page lists a range, but I've tried 1.8-2.1 and they all either crash or error out.

Could it be the FSB on the motherboard? The RAM is 800MHz and I'm running it at 668MHz so I highly doubt it's a RAM issue. I should note I had EIST and C1E on before and I had the FSB up to 350 with no problems, I Just went to 334 so I wouldn't have to adjust the CPU core. But it seems like I'm running things within or under spec and there's still crashing.

Anyone else having similar issues? Know a solution?

*edit* Using a gigabyte GA-965P-DS3; great board but doesn't show you how much voltage is going into anything, just how many volts over stock you can put them :T
 
Oops, forgot to mention that rather important point.

Using a Gigabyte GA-965P-DS3 Rev 3.3
 
Just ran some more small fft and orthos errored out so I'm going to try upping the Vcore. I guess 3GHz at stock voltage was aiming too high :(

BTW in CPU-Z at load, the voltage on the core fluctuates quite a bit; is this an accurate reading or is the BIOS setting the accurate one? BIOS says 1.35v, CPUz reads between 1.296 and 1.312; stock voltage for this chip afaik is 1.325 (can't find it anywhere :T)
 
The voltage drop is a "feature" intel uses to make cpus run cooler and consume less energy, so don't worry about it, it's normal.

As to your fsb problem, bump up the vcore of the cpu to 1.4 and MCH voltage to +0.1v. I can run my DS3 (don't know the revision) with an e4300 at 8 x 380 (with a pair of really shitty 667mhz memory at 5-6-5-15) orthos 10 hours+ stable and 9 hours of 3dmark06 loop (99 times each graphics test), so the mobo shouldn't crap out at 334 yet..
 
I disabled C1E and EIST so there is no more multiplier and voltage changing due to that (although the voltage changing when they were on was really wonky; at load the voltage was higher than stock). The voltage fluctuation just seems lower than stock; 1.325 ended up being a lot lower. This seems to have been a common issue for a while with motherboards vs monitoring software.

I'll try bumping the MCH up a bit and see if it helps, however, I was wondering, what exactly is the difference between FSB voltage and MCH voltage? MCH is the northbridge and FSB voltage is...? Yeah I dunno.

Forgot also to mention before I started OC'ing manually, I had the C1E halt and EIST enabled, and I had the mobo FSB at 350 with no problems; orthos was stable for about 2 hours before I started messing with everything. So 350 is stable enough, but I think the Vcore was up around 1.5 or so, which is a bit higher than I'd have liked. I'd like to raise the Vcore as little as possible to keep heat output low, hence why I tried 3 GHz on air to start, but for sure with higher voltages this chip and mobo can certainly go a lot higher.

Thanks for the responses.
 
Back
Top