opteron 165 ihs removal

sumofatguy

Gawd
Joined
Nov 21, 2005
Messages
889
Ok, I just removed the IHS on my opteron 165. what I was wondering is if I need to put electrical tape or some sort of insulator on the chips under the IHS around the centre core? Why I was wondering this is because I think arctic 5 is a conductor, and that would not be good spread all over in there. I have electrical tape on them right now, but the center core barely stands up above them and the tape, so I dont know if it is making good contact with the cooler. Thanks!
 
AS5 ISN"T a conductor... It's SLIGHTLY capacitive at high frequencies, however :).

I'd use it, I mean, why risk it... Just cut the electrical tape so it's only covering the SMD capacitors... Like, maybe strips that are 1/4 of an inch thick over top of them.
 
ok, sounds good. I was slightly concerned about the heatsink making proper contact with the core if i put tape on them. that shouldn't be a problem?
 
Another option if you're worried about using AS5 would be to use Arctic Silver's Ceramique instead.

When I removed the IHS off my Opty, I originally used Ceramique between the core and IHS, and then AS5 between the IHS and heatsink. Temps weren't low enough, so I got rid of the IHS completely, and used ceramique... also had to change the mounting method of my HSF to compensate for the lack of IHS (bolt mod)
 
NordicRX8 said:
Another option if you're worried about using AS5 would be to use Arctic Silver's Ceramique instead.

When I removed the IHS off my Opty, I originally used Ceramique between the core and IHS, and then AS5 between the IHS and heatsink. Temps weren't low enough, so I got rid of the IHS completely, and used ceramique... also had to change the mounting method of my HSF to compensate for the lack of IHS (bolt mod)

is yours water cooled then? my heatsink fits on just fine without modding the bracket too much.. and a little off topic, but what divider are you running your ram on at 2.2.2.6? we have quite a similar setup, and mine is on 166 at 2.7v running at 263.5mhz. what voltage are you at?
 
Back
Top