Opteron 165 Bios Overclock

[YoNeX]

I have some issues setting my overclock settings in my bios.
Opteron 165 CCBBE 0610 - Good for 320x9 via Clockgen @ 1.45 volts
Tuniq Tower 120
Kingston HyperX 2x1GB 2-3-2-6-1T - Good for 225mhz.
MSI Neo2 Platnium

I set the my memory divider to 133/200, HT Mult to 3x, CPU Mult to 9x, and FSB to 320. I'm pretty sure this board can reach 300+ FSB Now when I set these setting in my bios, the computer turns on, but my monitor doesn't respond so I can't even see the bios. So what could be the issue?

 

[txtmstrjoe]

My theory is that the "shortcut" method (ClockGen) has overlooked either a RAM timing setting or, more likely, your HTT link speed is completely out of whack.

Have you set your HTT link divider to lower than the default 5X in your BIOS?

 

[YoNeX]

My theory is that the "shortcut" method (ClockGen) has overlooked either a RAM timing setting or, more likely, your HTT link speed is completely out of whack.

Have you set your HTT link divider to lower than the default 5X in your BIOS?

Its at 3x. 3* 320 = 960 < 1000 (good)

 

[txtmstrjoe]

What about RAM timings? VDimm settings?

 

[YoNeX]

Turns out the issue was the 133/200 divider wasn't working right. So can't use it guess I can only use 100 and 166, bleh.