(UPDATES: further down, keep reading. Nothing new to see here 
I've got an upgrade scheduled for the future, so no remarks about my board needing to be carbon-dated for historical purposes.
ECS k7s5a.
Went through about a dozen restarts when installing a water cooling system recently (no leaks or water damage or anything)
each of these restarts was start, listen for pump/feel for flow, stop, adjust, etc. Didn't have an atx dummy wire so i just did it through the board with the case power button.
Now onto the problem. Every time I boot, the board complains of bad bios checksum, and dumps me into setup. I can change everything there normally, EXCEPT the fsb setting. (which on this board is about all there is). if the fsb is at anything other than 100/100, when i save and exit i get blank screen, and after a hard reset the board is defaulted back to 66/66 (something you can't even select in the bios)... so my choices are 850mhz with all onboard crap disabled, or 1257mhz with my settings in proper.
(athlonXP 2100, btw)
All changes in the bios that DON'T involve the fsb setting, when i save and exit will work properly. just don't touch that fsb...
So, I'm thinking that a bios reflash is either going to fix the problem completely, or finish off the board and make it totally unusable.
any help would be greatly appreciated. If anyone has seen something similar before, i'd love to hear about it.
I wanna get back to doom3, but 1.2ghz ain't cutting it
I've got an upgrade scheduled for the future, so no remarks about my board needing to be carbon-dated for historical purposes.
ECS k7s5a.
Went through about a dozen restarts when installing a water cooling system recently (no leaks or water damage or anything)
each of these restarts was start, listen for pump/feel for flow, stop, adjust, etc. Didn't have an atx dummy wire so i just did it through the board with the case power button.
Now onto the problem. Every time I boot, the board complains of bad bios checksum, and dumps me into setup. I can change everything there normally, EXCEPT the fsb setting. (which on this board is about all there is). if the fsb is at anything other than 100/100, when i save and exit i get blank screen, and after a hard reset the board is defaulted back to 66/66 (something you can't even select in the bios)... so my choices are 850mhz with all onboard crap disabled, or 1257mhz with my settings in proper.
(athlonXP 2100, btw)
All changes in the bios that DON'T involve the fsb setting, when i save and exit will work properly. just don't touch that fsb...
So, I'm thinking that a bios reflash is either going to fix the problem completely, or finish off the board and make it totally unusable.
any help would be greatly appreciated. If anyone has seen something similar before, i'd love to hear about it.
I wanna get back to doom3, but 1.2ghz ain't cutting it