Old Shuttle board and flash difficulty

Strikemaster

[H]ard|Gawd
Joined
Mar 29, 2001
Messages
1,264
Haven't seen this one, Shuttle's website hasn't been much help so far, maybe a [H]ard soul can get 'er done.

The board is a Shuttle HOT 661v11, a 440BX-based Slot 1 that we're trying to upgrade and use for a Linux server. As dug up from the scrap heap, it has a Celeron 300A (yes, THAT Celeron of old :D ) and a SCSI RAID subsystem. We found a P3-450 to drop in it, and thus began the tale of woe.

The current BIOS doesn't recognize the P3-450.

ALL freaking attempts to flash the BIOS have ended with the program freezing just after reading the .BIN or .ROM, floppy light stays on but not accessing the disk. The machine reboots successfully each time, old BIOS intact. Something is inhibiting the flash, but I can't find what it is. The machine is stripped bare; only the essentials (CPU, memory, video and floppy) are connected, and I've changed everything I can on the floppy string.
 
Some older boards had a jumper you had to move to allow flashing of the BIOS.

And you are doing this with the 300A installed, not the P3 correct?

==>Lazn
 
Originally posted by Lazn_Work
Some older boards had a jumper you had to move to allow flashing of the BIOS.

And you are doing this with the 300A installed, not the P3 correct?

==>Lazn
No jumper seen either in the manual or on the board.

After a few tense moments with Athlon XPs and older Socket-A boards, I know better than to just heave any CPU into a socket that it'll fit :D . All attempts were with the original 300A in place.
 
Success, but how, I don't really know.

Pulled EVERYTHING from the board.
Old video card was RageIIC AGP, threw in a S3 Virge PCI.
512meg of RAM, yanked all but one stick (128meg).
Reset CMOS via jumper yet again.

Booted via Win95 floppy, started the flash program. Ran to completion, no hiccups. WTF? :confused:

On reboot, new BIOS date confirmed.

P3-450 installed, reset RAM speed jumper after POST showed a P3-300 :D . System now on it's way to being the work tickets server for the tech support area (barring any more fsck-ups)...
 
Ah, you had all 3 simms filled. That sometimes causes "funky" behavior on BX chipset motherboards.

(only explanation I can come up with)

==>Lazn
 
Originally posted by Lazn_Work
Ah, you had all 3 simms filled. That sometimes causes "funky" behavior on BX chipset motherboards.

(only explanation I can come up with)

==>Lazn
Actually, this one had four slots, all filled with 128meg sticks.

I know, it just got weirder. Thankfully, it has the last flash it will ever get, so I don't have to go through THAT again... :D
 
I know my old Soyo board with a P3 450 I had to use a pci vid card to load operating system, flash bios anything that made any changes. Then I would put the AGP card back. No clue Why ?

I still have my old diamond stealth pci card just in case
 
Back
Top