Okay, what did I hook up wrong?

dparm

Limp Gawd
Joined
Jun 26, 2007
Messages
181
Replaced my CPU fan last weekend. It necessitated removing the mobo since the new cooler had a backing plate I had to install.

Somewhere along the lines I must have reconnected things wrong -- now the CPU fan runs even when the computer is shut down and I can still open/close the DVD drive drawer. The lights on the motherboard remain on too.

What could I have possibly reconnected wrong?

It's an eVGA 750i FTW.
 
The more I read about it, the more I think it's one of the motherboard connectors for the power switch or reset button. Time to rip things apart again...
 
Yes. Motherboard is an 8-pin for CPU, PSU only has a four connector. Worked fine before.
 
Tried swapping all the connectors for the front panel buttons and LEDs. No effect.

I am thinking the motherboard is going bad.
 
Weird, maybe try one stick of RAM at a time in case one got a static shock or something...?
 
Remove the motherboard from the case and set it down on a non-conductive surface (the top of the motherboard box usually works pretty well). Connect everything and start up the PC. See if the issue still occurs with the board out of the case.
 
Remove the motherboard from the case and set it down on a non-conductive surface (the top of the motherboard box usually works pretty well). Connect everything and start up the PC. See if the issue still occurs with the board out of the case.

I vote for this, seems like something got grounded when you reinstalled the motherboard.
 
Also check the case connectors for the proper orientation to pin one. Do not rely on the cable labels. Look for the embossed triangle on the plug.
 
Sounds like a shorted PS-ON line somewhere.

What happens if you disconnect everything from the PSU and then connect mains to it?
 
The backplate of the HSF is probably shorting out some solder-points on the back of the MB.

I think I would remove the MB from the case, remove the HSF and then the backplate and re-assemble it, watching for any contacts there on the backside of the MB. Then put it all back together and connect the PSU and see what you've got.:p
If that looks like the problem, put some masking tape on the underside(the side that touches the MB) of the backplate so it can't make electrical contact.

Sometimes if you tighten the backplate too hard it can contact solderpoints on the back of the board.
 
Back
Top