I installed an Agility 2 in my laptop and imaged the original WinXP installation over.
Everything was running fine until I flashed the drive to the 1.11 firmware.
Now, on bootup I get a bluescreen. If I keep attempting to boot the laptop by shutting it down. It will eventually boot into WinXP.
Any ideas? The OCZ forums report an issue with SMART reporting an error but it seems that it is limited to Gigabyte motherboards.
Should I flash back to 1.10?
Everything was running fine until I flashed the drive to the 1.11 firmware.
Now, on bootup I get a bluescreen. If I keep attempting to boot the laptop by shutting it down. It will eventually boot into WinXP.
Any ideas? The OCZ forums report an issue with SMART reporting an error but it seems that it is limited to Gigabyte motherboards.
Should I flash back to 1.10?