OCed Rig What to adjust here with adding a Gig.

G

Glow

Supreme [H]ardness
Joined
Jul 20, 2002
Messages
4,834
Alright heres the plan I have an OCed 3000+ @ 2.6Ghz with 2x512mb of HyperX 3500. Tomorrow or Saturday I am going to be adding an additional 2x512mb of HyperX 3500. Here are my settings, I would love it if I could just pop them in and all would be fine but how are my chances of that? Anyways here ya go:

SPD.jpg

memory.jpg

mainboard.jpg

CPU.jpg

cache.jpg


So this is what I have my settings at right now, what do you think I should adjust or will have to adjust once I install the new sticks of ram?
 
You most likely won't be stable at the same speed, but at the very least you'll need to be running 2T
 
I haven't OCed a damn thing in maybe a year and a half I had to go back and re-read a lot and get CPu-Z and clockgen again so please dumb every response down a bit for me. I miss how easy Bartons were to OC nforce 2 <3
 
Four sticks = 2T timings from what I understand. So you will be inherantly slower.
 
legendz411 said:
Four sticks = 2T timings from what I understand. So you will be inherantly slower.
Click to expand...

but let me remind you, it'll only be MAYBE 2-3% slower in real world apps. The only difference you'd notice is in benchmarks. I wouldn't really worry about it.
 
Yea, but I was just saying so he would know that it will slower. Synthetics mean alot to some :)
 
what settings if any do I need to adjust to 2T
 
Could it be labeled as something besides command rate? I dont see it anywhere. Will it also say 2T or does 2T mean a certain number/setting?
 
Glow said:
Could it be labeled as something besides command rate? I dont see it anywhere. Will it also say 2T or does 2T mean a certain number/setting?
Click to expand...
this is what you're looking for. You should see the setting as either 1T or 2T. You've got a DFI board, so I'm positive the setting is there. It'll be somewhere under the RAM settings.
 
I must be blind or something I dont see it. Is there normally numbers there or something?
I see DRAM Frequency set at the top where I can change like 166= Ram/FSB

Then I see Commands per clock
Auto
Enable
Disable
(I have it enabled)
to the right the description reads:
This field specifies if DRAM CMDs & address will be driven for 2 clock cycles enable to force 1T clock timing of CMD Address bus.

Is this it? If I put in my other 2 sticks of ram will it change to 2T then I should enable it? am I still not looking in the right place?
 
Glow said:
I must be blind or something I dont see it. Is there normally numbers there or something?
I see DRAM Frequency set at the top where I can change like 166= Ram/FSB

Then I see Commands per clock
Auto
Enable
Disable
(I have it enabled)
to the right the description reads:
This field specifies if DRAM CMDs & address will be driven for 2 clock cycles enable to force 1T clock timing of CMD Address bus.

Is this it? If I put in my other 2 sticks of ram will it change to 2T then I should enable it? am I still not looking in the right place?
Click to expand...

It looks like that's it. Disable it, save settings, reboot, and check in CPUZ
 
You must log in or register to reply here.
Back
Top