No Video After Card Swap

MannyZ

Weaksauce
Joined
Mar 10, 2004
Messages
88
Hi there,

Well I damaged my 9800 pro pretty bad somehow so I decided to swap it with my old 4800SE so I wouldnt have to stare at all these red dots/lines anymore. However when I did this I get absolutely NO Video signal from my 4800 at any time not even while booting. I have uninstalled all the old ATI drivers as well as run a driver uninstall utility. I also fully cleared my cmos and still no luck. Any suggestions?
 
Bump. Tis my bro, the 4800 works fine in his other system, just not the one where he swapped the 9800 out, is it possible for the memory to overheat? there was no ram sinks on the 9800, and the water block was installed hella tight, maybe not enough water flow?
anyways, hes pretty sure its dead:(. Any ideas on gettin the 4800 to work?
 
HA HA. Both cards work fine in my other rig man, well the 4800 works fine, the ATI still has the same problem. The ATI was fine until I installed one of those 3D screensavers off of the CD it came with. I left the computer on when I left the house last Saturday and when I came back Sunday my screen had all these pretty redish lines all over the place...
 
Just to let everyone know, we ended up sending this card in for an RMA and I also purchased another in the mean time. The new one is running great and ATI also sent out a new card to replace the dead one, which my lil bro is now running in his rig. Thanks for all yer guyz help and thanks to ATI for the awesome customer support. Ohh and thanks to my no-job-havin lil bro for taking care of the RMA for me :)
 
Back
Top