No Post/Power

  • Thread starter Deleted member 69395
  • Start date
D

Deleted member 69395

Guest
I just got my order from newegg, I got a 29$ mobo cuz it was for my cousin whos only interested in browsing the internet/audio type stuff, nothing intense as to get an 80$ board.

The Problem: I plug it all in setup all the wires/ribbons/jumpers and the front panel jumpers

Go to turn it on, NO POWER/ No post

Undo everything, reseat HS/F all that yummy stuff, re-checked the manual to confirm. Go to turn it on... Nothing

I thought PSU but I put the old 500Mhz shit in and it all powered up good...

Im at a loss, probably gunna RMA unless you guys have something else to check


edit** The only other thing I can think of is Imusing DDR333 and it only supports up to DDR266 but I coulda sworn it was backward compatible**edit
 
If the board only supports DDR 266 and nothing higher, then even though the memory can be slowed down in the BIOS, that doesn't mean the board will actually work with memory that is faster than the board is spec'd for. BUT you said it booted with a 500 mhz chip in? was that with the DDR 333 too?? Try DDR 266 or lower. Try testing the processor in another board
 
well no, the power should turn on anyway,even if the computer didnt boot it would still turn on and the 500mhz chip was the old mobo/proc, and they worked fine ruling out the PSU

The new things are actually Athlon XP 2000+ and come PC Chips board


I just assumed even if it didnt boot the fans would turn on
 
A number of things could be wrong. Here are somethings to check (in this order):

- Make sure you have the right connector on the motherboard. I have seem some that dont match the diagram the way you think it would. Easiest way to test is to unplug all the cables like the power, reset, hdd light, and power light, and just try connecting them with a flathead and see which ones work.

- Make sure the power supply can provide enough juice... if its not atleast a 300W or atleast a beefy 250W, then you may not have enough power. Great way to test this is with another power supply (say from your system) that has more juice.

- Make sure the fan connector for the cpu heatsink is plugged into the right connector. I have seen computers that dont boot unless there is a fan plugged into the CPU/FAN as a safety measure.

- Take the video card out, if things power up and you hear 3 beeps, that means the video card does not work in that system.

- Take the ram out, if things power up and you hear a constant, steady, repeating beep the ram does not work in that system (could be a voltage issue)

- Take everything out of the case, and run it ontop of some news paper. It could be the case is shorting out the motherboard on the back somehow (like a riser that gets left in, but doesnt match a hole on the motherboard).

- If that still doesnt work, take the cpu out and try to fire it up.

If all of the above fails, RMA it.
 
swoop56 said:
Try reversing the fron panel power pin.

This cannot make a difference since its just a short. It can be power using a flathead screwdriver.
 
Make sure the CMOS jumper is not in the clear position. Sometimes, for whatever reason, boards will ship like that. Lots of boards have a protection mechanism that will not allow them to power up when in this state. Worth a shot.
 
thats actually what happened. I figured it out before I saw this aka last night lol

thanks
 
Back
Top