No Display on Startup

Pegesus

Limp Gawd
Joined
Jan 9, 2003
Messages
304
Hey Quick Question:

I just finished a build and for the life of me I can't figure out why i cannot get a display on my LCD once i power up the PC.

I'm running the following:

AMD FX-57
Evga Dual 7950's
4 Gig RAM
EVGA Micro ATX SLi MB
WD Raptor
Silverstone 700w PSU

The system is completly new all parts where working properly and tested before build. System seems to boot up fine i get the initial startup system beep and then from there it seems to run fine. I just get no display my LCD just stays amber. I have enabled the SLi on the MB and checked all the jumpers unless i'm missing something.

Please help. Thanks. Its probably something mundane i just can't think of it.
 
yeah still nothing.

Just noticed tho on my MB the SYSLED light is constantly on and RED. Not sure why tho or if this has something to do with it.
 
Have you tried running the PC outside of the case?
 
Ok i reseated the video cards. I only put one in again. I reset my CMOS and placed the one video card in the Blue PCI slot. It worked i got a picture on startup.

Then i started over. Reseated the dual cards back in the 2 Yellow PCI slots. Swapped over to the SLi jumpers and powered the system on and nothing. I reset the CMOS and still nothing.

Now any ideas?
 
So it works with only video card in the plue PCI-E slot?

It could be a bad SLI connector. Try to see if you can get your hands on a new one.
 
Have you tried both cards in the blue slot? Might want to make sure they both function properly on their own. The only other simple solution I can think of is to make sure you have power going to both of them. Either that or your SLI somehow isn't configured correctly.
 
I'll try to find another SLi Bridge. But yeah both work in teh PCI-E slot. Heck they even worked once when i didn't have power connected to them which i found strange. I'll keep at it and let you know if anything changes.

Thanks for the help so far.
 
Back
Top