nForce3 Detecting Array

[nowei]

I have a Sempron 3100 w/ a DFI LanParty UT board and if I push the FSB past around 235~ MHz, I get the nForce "Detecting Array..." message right after post but before bootup, and then the system reboots. can't really figure out why it says that since this board has a SATA lock. Anyone have any ideas?

THanks

 

[lithium726]

you need to use the SATA ports on closest to the processor. those are the only ones that have the lock on them, IIRC

 

[nowei]

I see... I will try that, thanks