NF7-S problem, I'm stumped.

jigabite

n00b
Joined
Jul 11, 2004
Messages
22
Hey guys, I'm new here and I figured you all would be able to help me with this problem. I just put together a new system with:

Amd XP2500+
NF7-S V2
1 Gig Muskin PC3200
Sapphire 9600

It'll turn on but I keep getting a long beep repeating over and over again, no video output. My first thought was bad ram, so I replaced the first brand with the Muskin. I then tried another video card and it didnt change anything. I've ran it on two different power supplies both in and out of a case. I've reseated the heatsink a few times. Honestly, I was sure it was a ram problem, abit support also said ram or possibly a grounding problem. Like I said though, I've tried a couple different sticks of ram in all the positions, and run it out of the case. The only thing I havent tried is another CPU. Does this sound like a CPU problem or do you think I have a bad mobo? I'd appreciate any help you guys could offer.

Thanks again,
tyler
 
It could be something shorting out the board. Also make sure the jumper isn't set to clear mode (clear cmos mode). Some boards come with it set to that.
 
yeah cmos jumper is set in the normal position and i cant see a single thing that would short it out, i'm running it with the mobo sitting on antistatic plastic :)

tyler
 
I had this problem when I first built my system, and it was the ram. Not sure what could be causing it though if you tried switching it out already. :confused:
 
Try pushing the ram into the slot HARDER. If the board is new, those slots are virgin and require some stretching! You damn pervets :p
 
Ok, I'll try and mess with the ram some more, but I don't see how its possible to get it in any farther, the clamps on the slots are in place and it's inserted as far as it will go. Is it not possible that something else could be wrong here?

tyler
 
jigabite said:
yeah cmos jumper is set in the normal position and i cant see a single thing that would short it out, i'm running it with the mobo sitting on antistatic plastic :)

tyler


Aren't the outside of those bags covered in metal>? :(

May wanna try placing the motherboard in the case with the proper stand-offs.
 
The plastic I am using doesn't have any metal and I've tried it on standoffs also.

tyler
 
Ok, that was one of the surfaces I've tried it on, but I'm saying it does it all the time, no matter what it is sitting on.

tyler
 
I would replace the mobo and if that doesn't do it try replacing the ram once more.
 
Did you plug in the video card ? that makes a long beep over and over if not plugged in
stupid but no one has mentioned it
 
thanks for all the suggestions guys, I've tried one stick of various brands of ram and it doesn't change anything. And yes, I've plugged in two different video cards, both of which had no effect on the problem.

tyler
 
Back
Top